Fuse holder 500A Every vehicle's battery should be protected with a fuse about 30 cm from the battery itself. This way, in case of an accident the chance of a fire is reduced massively. Especially with heavy equipment in use, like a winch. For this reason, we strongly recommend protecting the electrics of your 4x4 by installing a proper fuse. This fuse holder usually installed in boats is more than just up for the job. The mount itself is good for up to 750 A, while the two 500 A fuses are perfect for operating a winch. The holder purposely ships with two fuses to never leave you stranded should the first fail. The lugs receive cables up to 50 mm². Of course, this holder is compatible with our dual-battery system. 

TEXU400 central electrics for touring vehicles and boats The TEXU400 revolutionises electrical installation. It combines various components that previously had to be purchased individually in a round housing that optimises the use of space and the number of possible connections in the smallest possible space. The special arrangement, which is ONLY available in the TEXU400, enables system integration with groundbreakingly low effort. This results in drastic savings in costs as well as time and space, while at the same time reducing sources of error and providing the highest level of application comfort after installation. It also requires considerably less installation space in a touring vehicle or boat. Extensive electrical systems can thus be planned in a smaller space and the space gained can be used for other purposes. Connection of up to 4 battery banks 11 high-current and 4 standard consumers Plus rail for on-board batteries and consumers Screw terminals and fuses 2x MEGA / AMG fuse max. 400 A 9x MIDI / AMI fuse max. 170 A 4x ATO / ATC / ATP fuse max. 30 A 1:1 ground distributionPut an end to insufficient ground distributions! With the TEXU400, a negative connection is also provided for each positive connection. Simple integration of a summation current measurementThe factory-fitted Sunt bridge between the negative busbars can be easily removed by means of screws and replaced by a plastic bar included in the scope of delivery to enable quick and uncomplicated integration of a measuring shunt. MEGA fuse with double inputWhere cable lugs used to be stacked or other suboptimal constructions had to be devised on a case-by-case basis (e.g. in the case of split cables of powerful inverters), there is now a professional solution: a MEGA fuse point with max. 400 A and double screw connection, ensures professional and safe installation of such components. Ignition-protected according to ISO 8846The UFO is ignition-protected according to ISO 8846 with the integrated, all-round bar with seal. It is therefore also approved for installation in the engine compartment. LED failure check with fibre optics Immediate diagnosis. Fibre-optic cables light up the LED failure check directly at the inscription of the circuits in the closed cover. You can save yourself the trouble of removing fuses and searching upside down for faults in confined spaces! A prefabricated labelling set with partly customisable content is included in the scope of delivery of the TEXU400. Space for spare fusesThe TEXU400 contains additional slots for spare fuses (1x MEGA, 2x MIDI, 2x ATO/ATC/ATP)Convenient opening and closingThe knob centrally located on the enclosure cover makes it easy to open and close the cover and even allows one-handed operation in confined spaces. Please note: As individual electrical installations contain different components that must be suitably fused, a prefabricated fuse set is NOT included directly in the scope of delivery of the TEXU400.