similar article
Mini CB radio with microphone AE6110 from Albrecht The ALBRECHT AE 6110 has all the essential functions that you need. The highlight: With a width of only 10 cm and a height of 2.5 cm, it can easily be accommodated even in the smallest of spaces. With its die-cast housing, it is very stable. New: with integrated VOX function for hands-free speaking in the vehicle Properties: All European CB standards S-meter, 6-level LED indicators for RX and TX VOX hands-free function Receiving sensitivity adjustable (RF gain) Channel 9/19 direct selection button (EMG) Die cast housing 4 watt AM / FM Automatic squelch (ASQ), adjustable in 9 levels Further equipment features: Channel selection buttons on the microphone Channel search (scan) Keylock Socket for external speaker Technical specifications:Dimensions: 102 x 100 x 25 mm³Weight: 450 gSupply voltage: 13.2 V.Power consumption: 2 A max.Operating temperature range: -20 to +50 ° CAntenna input: UHF, SO-239Frequency error: <+/- 300 HzTransmission power: 4 wattsInterference transmissions: <4 nW (-54 dBm)Adjacent channel power: <20 µWFM frequency deviation: <1.9 kHzAM modulation depth: <90%Reception sensitivity: better than 1 μV (20 dB SINAD)Mirror selection: 70 dBAdjacent channel suppression: 60 dBAudio output: 1 watt into 8 ohmsFrequency response: 300-3000 Hz Conversion option for licensed amateur radio operators:10 m amateur radio band, 400 channel mode: 25,610-30,105 MHz, 8 watts Scope of delivery: AE 6110 CB radio, microphone with up / down buttons, microphone holder, mounting bracket with screws, instructions
Prices incl. VAT;
The CB-radio VOX microphone offers the perfect solution for hands-free communication in any vehicle, following § 23 (1a) of the German road traffic regulations. This paragraph outlaws the usage of handheld microphones since the 01.07.2020. This microphone can be used with almost all CB-radios on the market to date. It comes with active noise canceling to filter out any background noise, to guarantee clear communication. The battery lasts about 60h and can charge while in use. Details: hands-free communication, following § 23 (1a) of the German road traffic regulations. This paragraph outlaws the usage of handheld microphones since the 01.07.2020 active noise canceling, eliminating irritating background noises VOX sensitivity adjustable in 4 levels VOX delay adjustable in 4 levels impedance: 4.7K ohm sensitivity: -58db 3000mAh battery (rechargable) 60h battery life micro-USB charging port Up/Down button plug: 4-point connector Scope of delivery:VOX microphone, instructions, USB charging cable Compatible with:Midland M10, Midland M Zero Plus, Alan 100 Plus B, diverse Präsident Geräte, Lavayette, etc.
Prices incl. VAT;
The Albrecht CB-radio VOX microphone offers the perfect solution for hands-free communication in any vehicle, following § 23 (1a) of the German road traffic regulations. This paragraph outlaws the usage of handheld microphones since the 01.07.2020. This microphone can be used with almost all CB-radios on the market to date. It comes with active noise canceling to filter out any background noise, to guarantee clear communication. The battery lasts about 60h and can charge while in use Details: hands-free communication, following § 23 (1a) of the German road traffic regulations. This paragraph outlaws the usage of handheld microphones since the 01.07.2020 active noise canceling, eliminating irritating background noises VOX sensitivity adjustable in 4 levels VOX delay adjustable in 4 levels impedance: 4.7K ohm sensitivity: -58db 3000mAh battery (rechargable) 60h battery life micro-USB charging port Up/Down button plug: 4-point connector Scope of delivery:VOX microphone, instructions, USB charging cable Compatible with:Midland M10, Midland M Zero Plus, Alan 100 Plus B, diverse Präsident Geräte, Lavayette, etc.
Prices incl. VAT;
Albrecht CB radio VOX microphones offer the perfect solution for hands-free communication in vehicles in accordance with Section 23 (1a) of the Road Traffic Act, which prohibits the use of microphones by hand in vehicles from July 1st, 2020. These microphones can be used with almost all CB radios on the market. The integrated active noise cancellation function filters out disruptive background noise and offers very clear voice transmission. The integrated battery has an operating time of approx. 60 hours and can also be charged while the microphone is in use. Properties:► for hands-free communication in the vehicle (compliant with § 23 (1a) StVO, which prohibits the use of microphones by hand in vehicles from July 1st, 2020)► Active Noise Cancellation filters out disturbing background noise► VOX sensitivity adjustable in 4 levels► VOX delay adjustable in 4 levels► Impedance: 4.7K ohms► Sensitivity: -58db► Up / Down buttons► integrated battery 3,000 mAh (rechargeable)► Operating time: approx. 60 hours► Can be used while charging► Micro-USB charging socket on the microphone► Connection: 6-pin CB radio plug
Prices incl. VAT;
Permanently good reception with the CB fixed mounting antenna The 1/4 lambda antenna is easy to mount and offers a wide bandwidth incl. DV connection. It consists of a stainless steel radiator with flux points and a wing nut. The standing wave ratio is preset and can be changed by changing the radiator length. Mounting instructions: Drill a hole with a diameter of 12 mm at a point on the vehicle body.Deburr the hole and ensure a good conductive connection of the antenna flux.Then insert the antenna base from the outside of the body into the hole so that the corrugated side of the antenna joint faces the outside of the vehicle. Fit the plastic washer and the metal trident washer the right way round. Fit the toothed washer and screw on the nut loosely After aligning the base, tighten the nut on the inside of the body with a spanner Screw on the angle plug with the antenna cable (tip: seal with silicone to permanently seal the mounting point against rust) Mount the radiator with the threaded bolt on the antenna base Technical data: Frequency: MHz 26-28 Type: 1/4 Lambda Power rating: 300 W Radiator length: 130 cm Steel material: Stainless steel SWR Adjustable - SWR adjustment via length change: SWR preset Special features: Plug type DV Total length with base: 138 cm The antenna has a cable with an open end to make it easier to lay the cable. For connection to a radio set you still need a PL259/6 plug for RG58 coaxial cable.
Prices incl. VAT;
Magnetic base antenna for CB radio, approx. 145 cm long. Technical data: Type: 5/8 LambdaPower rating: 200 WLength of steel: 148 cmRadiator material: stainless steelMagnetic base: 120 mm diameterThe antenna has a cable with an open end to make it easier to lay the cable. For connection to a radio set you still need a PL259/6 plug for RG58 coaxial cable.
Prices incl. VAT;
you might also be interested in
Plate for mounting a CB radio antenna on the air intake (RHD) This mounting plate ensures optimum mounting of a CB antenna on the air intake of the Land Rover Defender. For this purpose, the mounting plate is installed on the right-hand (as seen from the driver's seat) ventilation grille / air intake. For left-hand drive vehicles, you can find the mounting plate here in our shop. As the Defender is made of aluminium, unfortunately no magnetic antenna base will hold. We have therefore designed a plate made of sheet steel with a suitable opening for the cable. This plate allows you to attach an antenna with a magnetic base, which you can easily remove if necessary. Scope of delivery: - Mounting plate - 1 m ground cable - Mounting material
Prices incl. VAT;
Adapter for Connecting Two Alan PL259/6 Connectors This adapter allows easy and secure connection of two Alan PL259/6 connectors. Ideal for use in radio communications, antenna installations, or for extending coaxial cables.Made from durable materials to ensure reliable signal transmission and long-lasting performance. Features: Compatible with Alan PL259/6 connectors Compact design Easy to use Perfect for radio and antenna applications
Prices incl. VAT;
Defender CB antenna mount – air intake mount, magnetic or fixed This mounting plate optimally attaches a CB antenna to the air intake of the Land Rover Defender. For this purpose, the mounting plate is installed on the left (as seen from the driver's seat) ventilation grille / on the air inlet. For right-hand drive vehicles (UK), please contact us by phone or e-mail. Please select the suitable variant for you: fixed mounting or as a magnet. Delivery: mounting plate 1 m ground cable mounting material
Prices incl. VAT;
Perfect mounting on the vehicle - antenna holder for the bumper The Nakatanenga antenna holder allows easy mounting of an antenna on the OEM bumper of the Land Rover Defender 90/110/130, making it easy to attach a CB or amateur radio antenna. The holder is made of stainless steel.
Prices incl. VAT;
Alan Funk 90 CB antenna for fixed mounting, length approx. 90cm, 200W, 4m cable with DV connector
Radio 90 CB antenna for fixed mounting
Technical data:
- Length approx. 90 cm
- 200 W
- 4 m cable with DV plug
- 1/4 lambda
The antenna has an open-ended cable to make it easier to lay the cable. A PL259/6 plug for RG58 coaxial cable is required for connection to a radio.