Not only for healights, but also for all other signal lights on the vehicle LED bulbs have many advantages, apart from low power consumption and high light output, there is above all superior longevity and vibration resitance that make these bulbs desirable for owners of off-road vehicles. The standard-set with 8 bulbs contains: 2x front indicatior ligths 2x front position lights, either with or without day-driving light 2x rear indicators 2x brake/rear lights adjustable indicator relay The set with 9 bulbs additionally (aditionally to the standard-set) contains:  1x tailgate break light The sets with 10 bulbs additionally (aditionally to the standard-set) contain:  → 1x fog light and 1x reverse light→ OR 2x wing side indicators The sets with 11 bulbs additionally (aditionally to the standard-set) contain:  → 1x fog light, 1x reverse light and 1x tailgate break light→ OR 2x wing side indicators The set with 12 bulbs additionally (aditionally to the standard-set) contains:→ 1x fog light and 1x reverse light and 2x wing side indicators The set with 13 bulbs additionally (aditionally to the standard-set) contains:→ 1x fog light and 1x reverse light, 2x wing side indicators and 1x tailgate break light With each kit you have the choice of orange or white bulbs for the indicators. Note that indicators must be orange by law. The fog light is always supplied in red. If the lamps on the existing vehicle are square at the rear, 1x AMR3850 mounting base is required per lamp in order to mount the new round rear fog lamp and reversing lamp. As a rule, the original drill holes can then be used. All bulbs come with E-approval so that they can be fitted without further TUV recording. All bulbs come with correct plugs for simple replacement for vehicles from MY 1998 (TD5 und TD4). Fittings are supplied, as is an adjustable indicator relay that even allows to adjust indicator speed. Older vehicles can be retrofitted after removing the plug. This requires soldering. There is no need for an external day-light driving control unit as this is already included in the position lights for day-light driving function. The wiring for day-light driving requires some straight-forward soldering - illustrated instructions are supplied. As required by law, the day-light driving light illuminates with running engine and switches off once low-beam is selected. This signal lights kit is the ideal addition to our 7" Bi-LED main headlights, the LED license plate light and any additional LED spotlights - this brings the Land Rover Defender into the 21st century light-wise! Signal lights (indicators, position lights with or without day-driving lights, brake lights, fog light and reverse light, wing side indicators) in LED technology for Land Rover Defender. E-marked, white or coloured, various sets available. Plug&play for LR plugs for TD4/TD5 (from MY1998). Please note: The screws must not be over tightened (only hand-tight!), Otherwise the plastic housing may crack. These cracks could allow water to penetrate into the generally watertight luminaires. Use only a screwdriver and NO cordless screwdriver!

Robust main headlamp with integrated low beam, high beam & position light - stainless steel mounting included NOLDEN 7" Bi-LED main headlight kit with two headlamps with low-/high-beam and position light, including stainless steels bezels. Price advantage! Innovative 7" LED main headlight with proven reflector technology combines low- and hight-beam as well as position light in one lamp. Original dimensions and standard H4 socket mean that this is an easy to fit, durable replacement upgrade for any Land Rover Defender 90/110/130. Price for one lamp! Also fits (in some cases with additional apaptors or wiring looms) other vehicles, like Jeep Wrangler JK/TJ/CJ, various Toyota, Mercedes G etc. The integrated electronic driver / control unit makes for easy fitment. NOLDEN headlights are road legal, of course. They have ECE (also known as E-marked) and SAE approval and are available for either LHD (EU version) or RHD (UK version) vehicles. You can choose between light-crome and darker dark-crome looks. Compared to traditional halogen headlights LED lights offer many advantages: higher light output ("more light") more comfortable light ("white light"), closer to sunlight low energy consumption (32/39 W compared to 55/60 W low/high-beam) vibration and shock proof design (especially important for diesel cars or off-road use) never again (ca. 30.000 hrs lifetime) white road Illumination compatible with HID/Xenon one of the brightest LED high and low beam 7“ headlights available Many users of classical vehicles, especially off-road vehicles (Defender, Wrangler, G-Wagon) have been looking for modern headlights with classical looks. Up to now 7“ LED headlights had offered better illumination than halogen headlights, yet they didn't give optimum illumination or were of inferior design. In addition these were often retrofitting solutions that didn't meet OEM specifications. The new NCC 7“ Bi-LED headlight was especially tailored to meet the OEM requirements. All components, from the LED to the plug, are designed and produced accordingly making up a perfect overall system. The design of the 7“ Bi-LED headlights reminds more of a conventional halogen headlight that looks like the well-known classic design. The familiar appearance of the vehicle is thus not changed much and essentially still looks like “OE“. The illumination level of the new NCC 7“ Bi-LED headlight is equally good as that of a Xenon headlight. However, the new NOLDEN headlight system has the big advantage of a lower current consumption, which increases the life of the system significantly thus noticeably lowering the operating costs. In a normal case it can be expected that the life of the NCC 7“ Bi-LED headlight is much longer than that of the vehicle. The ligths don't require headlight adjustment or the headlight cleaning system of the Xenon system, retrofitting with the new NCC 7“ Bi-LED headlight is therefore much easier, faster and in the end less expensive than is the case with the Xenon headlights.  Technical details: dimensions in mm: 177 x 152 number of LED: 5 x Osram Automotive output (low-/high-beam): 32 W / 39 W voltage range: 9-32 V lumens calculated: 1.880 lm / 2.400 lm lumens measured: 1.550 lm / 1.700 lm fixing: PAR56 homologation: ECE, SAE front lens: UV resistent polycarbonate hard coated front lens housing: lightweight, rigid alumium housing waterproof: 480 h salt spray tested and fully water proof to IP6K9K NOLDEN Bi-LED main headlights are also suitable and approved for many European, Asian and American motorbikes. Also note our lower-price vehicle-dependent bundles for Jeep Wrangler JK, Mercedes G and Toyota LandCruiser HZJ. Please note that these lights have position lights. You can use the standard Defender position lights along with the headlight position lights, or you disconnect the position light of the NOLDEN lamps. You receive a complete fitting kit, including two lamps and fitting material for your vehicle. The Nolden LED lights are available in chrome, dark-chrome and matt black, the stainless steel bezels either in "stainless" or black powder coating. These lights are also available for RHD verhicles. Please choose the desired version. IMPORTANT: We do not ship the right-hand drive / left-hand traffic versions to UK.UK customers please visit www.4x4overlander.com for the RHD/LHT headlights.

More Light, Better Visibility: The Interior Light for Your Land Rover Defender! Sound familiar? You're out and about with your Landy, it's getting dusky or it's already pitch black, and you're looking for something inside. The original interior lighting in your Defender is often more of a glimmer than a real light that provides orientation. That ends now! With our high-quality interior light, you finally bring the brightness into your Defender that you deserve. Whether you want to read maps in the dark, sort your gear, or simply create a pleasant atmosphere – this light makes the difference. Why You Should Opt for This Interior Light: Significantly Improved Light Output: Experience a noticeably brighter interior compared to the often undersized standard lighting. Optimal Illumination: Ensures better light distribution, so even dark corners of your Defender are better lit. Easy Orientation: Find tools, equipment, or that life-saving chocolate bar faster and without a long search. Pleasant Ambiance: Creates a functional and simultaneously pleasant lighting situation in your iconic vehicle. Robust Construction: Made for demanding use in the Defender – it withstands the vibrations and conditions your Landy masters. Perfect Fit: Designed to integrate well into your Defender's interior and to be easily exchanged for the original part. (Note: Please check specific model compatibility and installation instructions if applicable.) Put an End to Dim Lighting! This interior light is a small upgrade with a big impact. It not only increases the practical utility of your Defender in everyday life and on adventures but also provides an extra plus in comfort. Equip your loyal companion now with lighting that does justice to its character. No more fumbling in the dark – treat yourself to clear visibility inside your Land Rover Defender! Interior light for all Land Rover Defender 90/110/130 models, replacement for the original part between the sun visors, also suitable as lighting for the second row of seats in conjunction with the roof console. This is a high-quality genuine Land Rover OEM part, not an inferior reproduction. You can find a suitable replacement festoon bulb HERE in the shop. Do you have questions about compatibility or installation? We at Nakatanenga are, as always, here to help and advise you!

Optimum illumination for your Land Rover Defender LED lights also offer advantages for interior lighting, like high light output, minimum power consumption, maximum vibration resistance and life expectancy. This is why we have asked a renowned automotive component supplier to produce an interior LED light for the Land Rover Defender for us. Our Nakatanenga LED Interior Light allows easy "plug & play" replacement of the standard interior light (front and back) of your Land Rover Defender. Lamps are sold separately, if you want to replace both lights please order this item twice. The cover and bulb of the existing light (AMR3155) are removed, the adaptor, LED circuit board and the new cover with switch are fitted - that's it, all tool-free and taking no more than 5 minutes! All previous functions of the interior light (on/off/door on) are kept, additionally you can switch to red light, which increases visibility at night. The last colour setting is stored.This is also useful for hunters or when hunting, as game perceives red light much less as an irritation than white light. Keyword eye adaptation: Red light is also used to avoid interrupting the dark adaptation of the eyes, as the eye reacts much more strongly to white light from a lamp, even at low brightness. As some dislike the typical cold-white light of many LED lights, we can also supply a version with warm-white (slightly 'yellower') light output. Unlike many other aftermarket lights, our LED interior light maintains the looks of the original. Can be used both for the front and rear interior roof light. Technical details: light colour (warm-white): 4.500 kelvinlight colour (cold-white): 6.500 kelvinwavelength (red light): 625 nmvoltage: 12 V (not suitable for 24 volts vehicles!)voltage range: 11-18 Vpower drain (at 12.8 V): 0.15 A (white light)power drain (at 12.8 V): 0.05 A (red light) Fits for all Defenders from 1985 to 2016 ATTENTION! The interior light can only be used in combination with the original Land Rover base. Please choose our universal bundle if you want to fit elsewhere or to a different make of vehicle.