Cargo rail nut 2.0 available in size M8 and V4A precision casting and thus best suited for exterior use. The nut is held securel in place with the stainless clip and can stay in place all the time. This makes it interesting for interior use, too, e.g. when fixtures have to be removed temporarily from the vehicle and will be fitted to the same place again. There are no protruding bolts, the nut can stay at its place, fitting is facilitated as the clip can cope with lateral force before fully tightening down, too. Once torqued down, the ribbed outer of the nut tightly grabs into the cargo rail, preventing any twisting or movement under load. The cargo rail nut 2.0 allows flush fitting of optional equipment and fixtures as the nut sits level with the rail and does not protrude above it. Additionally the clip acts as a washer, thus increasing the contact area, expecially in the rounded version of the airline cargo rails, while also protecting painting/anodisation. Four markers facilitate to mark the drill centre. Advantages: rustfree - nut made of high-quality V4A precision casting, clip of stainless EN 1.4310 steel simple handling - fit nut, secure with clip, bolt on equipment innovative - can be fitted to ANY part of the cargo rail and doesn't have to be pushed in from the side nut sits level and does not protrude - equipment can be bolted on flush secure - sits securely in the rail and stays where it was fitted - does not get out of place, even with nothing bolted to it. Markers in the clip to facilitate drilling, clip acts as a washer.

Saving Bundle! Here you get the perfect set for your load securing! Simply add additional attachment points to your vehicle.The lashing points and single studs are flexible and therefore always in the right place!Fast and safe installation. One bundle consists of:6 pieces lashing points (diameter 45 mm, thickness 10.3 mm)6 pieces Single Stud (load 300 kg, ring diameter 40 mm, anodized aluminum, UV and salt water resistant) 5 sets (30 pieces lashing points + 30 pieces single studs) cost only 100€! Only while supplies last!* Compared to single purchase

Lashing rail accessories - M8x45 screw fitting with nut and washer The M8x45 screw fitting is a practical accessory for lashing rail systems. It is supplied with a nut and washer and is ideal for securely fastening load securing elements. Thanks to the standardised thread size M8 and the length of 45 mm, it is versatile and provides a reliable connection.