VIAIR Compressor Kit - Escapade Constant-Duty Ultra Compact, 12V, for fixed installation

Escapade Constant Duty Compact  Onboard Air System

For up to 37″ Tires
P/N 50003 – 110/145 PSI – 150 PSI / 1.80 CFM

VIAIR’s Escapade Constant Duty Compact Onboard Air System is a compact, pre-packaged compressed air solution that features an industry-leading, 150PSI rated, 100% duty 450C compressor, an extruded aluminum tank, and all components needed to install a working system capable of tire inflation and air locker actuation. This OBA System comes complete with an onboard pressure switch, automatic coupler and a tire Inflation Kit.

SPECIFICATIONS

• 12-Volt
• Permanent Magnetic Motor
• Duty Cycle: 100% @ 100 PSI 
• Max. Working Pressure: 150 PSI
• Max. Amp Draw: 23-Amps
• Ingress Protection Rating: IP67
• Dimensions: 9.38″L x 4″W x 6.75″H
• Net Weight: 12.5 lbs.

FEATURES

• 450C 150 PSI VIAIR Compressor w/ Thermal Overload Protector (1)
• Extruded Aluminum Air Tank (1)
• Sealed Pressure Switch (110 PSI on, 145 PSI off) (Pre-installed) (1)
• Sealed 40-Amp 4-prong Relay with pre-wired female socket (1)
• 40-amp Relay Sealed 4-prong relay w/pre-wired female socket (1)
• Tire Inflation Gun with 160 PSI Gauge (1)
• 30ft. Coil Hose with Quick Connect and Stud (1)
• Rubber Tipped Blow Gun (1)
• Quick Connect Coupler (Pre-installed) (1)
• 1/4″ 175 PSI Safety Valve (Pre-installed) (1)
• 1/4″ NPT Plugs Kit (Pre-installed) (1)
• 1/8″ Drain Cock (Pre-installed) (1)
• 1/4″ NPT to 1/8″ BSP Adaptors (2)
• Air Filter Housing w/ Replacement Air Filter Elements (1)
• 20ft. Freeze Resistant 12-Gauge Wire w/ Inline Fuse Holder (1)

FILL RATES
31″ X 10.5″
0 to 30 PSI 4 min. 05 sec. (±10 sec.)
15 to 30 PSI 2 min. 10 sec. (±05 sec.)
33″ X 12.5″
0 to 30 PSI 5 min. 30 sec. (±15 sec.)
15 to 30 PSI 2 min. 50 sec. (±05 sec.)
35″ X 12.5″
0 to 30 PSI 6 min. 55 sec. (± 15 sec.)
15 to 30 PSI 3 min. 30 sec. (± 10 sec.)
37″ X 12.5″
0 to 30 PSI 7 min. 56 sec. (± 15 sec.)
15 to 30 PSI 4 min. 09 sec. (± 10 sec.)

Please Note: Use thread sealant for proper installation. Thread tape is not recommended.
Properly sealed, recommended torque for 1/8” is 10 ~ 11 ft. lbs. Recommended torque for 1/4” and 3/8” is 16 ~ 18 ft. lbs.