Suzuki Jimny GJ / HJ Adapter cable PS13W to Superseal 3-pin Hard-working 4x4s like the Suzuki Jimny GJ / HJ benefit greatly from partial or complete conversion to LED lamps and lights: as a rule, LEDs tend to shine brighter while using less energy, are not as prone to failure and last longer than bulbs. If you want to customize your Jimny GJ / HJ with combined LED daytime running and fog lights, e.g. Nolden 90 mm LEDs, you will need 2-pin PS13W socket to 3-pin AMP-Superseal plug adapter cables to connect the daytime lights. The fog lamps are plug & play. The complete installation kit consisting of two adapter cables and one pair of Nolden LED daytime running/fog lights in chrome housing can be found here. Adapter:2-pin PS13W socket to 3-pin AMP-Superseal plug.

Chequer plate supports for Suzuki Jimny 2 by TREKFINDERSuitable checker plate supports for SUZUKI Jimny 2 from 10/2018 (model GJ / HJ)Material: Aluminium AlMg3 sea water resistant For mounting on the front bumper, right & left side. (see product pictures)The product can be painted by you or coated with RAPTOR paint. Supplied in pairs incl. screws.

Lifting suspension TREKFINDER for SUZUKI Jimny II type GJ from 10/2018 / HJ - the lifting is about 40-50 millimeters. Suitable for model / vehicles:Jimny type GJ from 2018 > / HJdepending on variant: with / without installed cable winch in front depending on variant: with / without steel braided brake line setwith or without LED light with manual transmissionwith automatic transmissionwith 1,5 L engine 75 Kwwith axle loads VA 680 Kg / HA 880 Kgwith ABE-EG number: e6*2007/46*0253*.. oder e6*2007/46*0515*.. SCOPE OF DELIVERY 1-SUJI2F1: 2 pieces TREKFINDER coil spring front axle, progressive wound, Made by H&R®.2 pieces TREKFINDER coil spring rear axle, progressively wound, Made by H&R®.2 pieces TREKFINDER shock absorber front axle, monotube gas pressure B6, Made by BILSTEIN®2 pieces TREKFINDER shock absorber rear axle, monotube gas pressure B6, Made by BILSTEIN®4 pieces TREKFINDER steel braided brake line, stainless steel & protective jacket, Made by LUCAS GIRLING®1 piece TREKFINDER mounting kit for models with LED headlight1 piece TREKFINDER TÜV® parts certificate SCOPE OF DELIVERY 1-SUJI2F2: 2 pieces TREKFINDER coil spring front axle, linear wound, Made by H&R®.2 pieces TREKFINDER coil spring rear axle, progressively wound, Made by H&R®.2 pieces TREKFINDER shock absorber front axle, monotube gas pressure B6, Made by BILSTEIN®2 pieces TREKFINDER shock absorber rear axle, monotube gas pressure B6, Made by BILSTEIN®4 pieces TREKFINDER steel braided brake line, stainless steel & protective jacket, Made by LUCAS GIRLING®1 piece TREKFINDER mounting kit for models with LED headlight1 piece TREKFINDER TÜV® parts certificate SCOPE OF DELIVERY 1-SUJI2F3: 2 pieces TREKFINDER coil spring front axle, progressive wound, Made by H&R®.2 pieces TREKFINDER coil spring rear axle, progressively wound, Made by H&R®.2 pieces TREKFINDER shock absorber front axle, monotube gas pressure B6, Made by BILSTEIN®2 pieces TREKFINDER shock absorber rear axle, monotube gas pressure B6, Made by BILSTEIN®1 piece TREKFINDER mounting kit for models with LED headlights1 piece TREKFINDER TÜV® parts certificate SCOPE OF DELIVERY 1-SUJI2F4: 2 pieces TREKFINDER coil spring front axle, linear wound, Made by H&R®.2 pieces TREKFINDER coil spring rear axle, progressively wound, Made by H&R®.2 pieces TREKFINDER shock absorber front axle, monotube gas pressure B6, Made by BILSTEIN®2 pieces TREKFINDER shock absorber rear axle, monotube gas pressure B6, Made by BILSTEIN®1 piece TREKFINDER mounting kit for models with LED headlights1 piece TREKFINDER TÜV® parts certificate Translated with www.DeepL.com/Translator (free version)

Mudguard widening kit for the Suzuki Jimny I FJ from TREKFINDER - 4 pieces, each 150 cm long / tyre tread cover 20 mm / incl. TÜV® / universal mounting Ideal e.g. with the 56 mm wheel spacer from TREKFINDER in combination with 215 tyres on 5.5J standard rims !!! Inexpensive and flexible wing flares in very good quality indestructible and therefore durable mudguard extensions made of black rubber the fender flares are glued to the existing wing flares of the Jimny and additionally fixed with screws (the screws are not included in the scope of delivery) the factory backing film is removed and the fender flares are then glued to the clean surface SCOPE OF DELIVERY: 4 TREKFINDER mudguard extensions, 150 cm each 1 TÜV® test report 1 type plate 1 piece assembly instructions 1 photo sheet ATTENTION - important installation instructions: the mounting surface must be smooth, rust-free, thoroughly cleaned and free of grease the outside temperature and the temperature of the components or mounting surface at the time of installation and for a period of 24 hours thereafter must be at least 20° Celsius after removing the 3M tape carrier film, the widener must be pressed evenly against the mounting surface for approx. 1 minute with high pressure adjust the ends of the widening to your taste with a sharp carpet knife to match the look of the vehicle Please allow the vehicle to stand for at least 24 hours after installation, preferably 48 hours the final strength of the bonding is only achieved after 48 hours Please do not wash the vehicle for at least 48 hours in some installation situations, especially if the installation instructions cannot be adhered to, additional fastening with e.g. self-tapping screws, body adhesive, primer is recommended  

Highflow sports air filter for Suzuki Jimny2 (GJ) Since the combustion engine is basically an air pump - air is sucked in at one end, then burned as a fuel mixture and expelled again at the other end - it benefits when not only individual components are optimized, but the entire system. In addition to chip tuning, which optimizes combustion, the air intake and exhaust system should also be optimized - i.e. tuned - as this is the only way to achieve optimum results and make the most of investments. As is so often the case, the whole is more than the sum of its parts. One of the simplest and cheapest options here is to replace the original air filter with a model with increased air flow. K&N is the inventor and manufacturer of the original when it comes to washable and reusable high-performance air filters. Each air filter is designed for increased performance and a lifetime of durability. The filtering effect remains intact over the entire period. K&N offers a 1,600,000 km warranty on every air filter (filter frame and filter media) in addition to the statutory warranty. Cleaning the K&N air filter is usually not necessary before 80,000 km. You too can rely on the 35 years of experience of the market leader in performance air filters! We offer air filters for almost all cars and off-road vehicles. Buy a K&N and experience the difference: 1,600,000 km warranty. This warranty is independent of the existing free statutory warranty rights. The statutory warranty rights are not restricted by this warranty. performance-enhancing - the higher air flow rate leads to improved acceleration/draft economical: a K&N air filter lasts for the entire service life of your car, motorcycle or off-road vehicle Registration-free Motorsport proven - number 1 in motorsport worldwide Cotton, washable Up to 40% more air flow Saves maintenance costs - no need to buy a new expensive factory paper filter at every inspection Environmentally friendly - its long service life reduces waste and protects trees Cleaning usually only necessary every 80,000 km No more filter changes - the oil-impregnated cotton fabric of the filter ensures a maintenance-free service life, during which the filter only needs to be cleaned and re-oiled from time to time. The filter only needs to be cleaned when a 2-3 mm thick layer of dirt has formed on the filter material. To clean your K&N sports air filter, please only use the K&N cleaning kit provided for this purpose.

Upgrade rear door damper for Suzuki Jimny 2 GJ/HJ Rear doors on off-road vehicles have to be heavyweight athletes, as they often carry spare wheels and other equipment. Especially when the vehicle is parked on uneven surfaces, opening tailgates – or keeping them open – can be a difficult and heavy task. For the Suzuki Jimny 2 (from model year 2018), we offer an easy-to-fit plug & play solution that does not require any modifications to the vehicle itself. The replacement damper for the rear door is calibrated to an opening angle of approximately 3. That means once you’ve pulled the handle and opened the door to that angle, the damper automatically and gently pushes the door fully open and keeps it in position – even when you’re parked at an angle on slopes or in off-road terrain. Another advantage of the heavy duty damper is the wider opening angle (slightly over 90°) when compared to the original part.