Retrofittable Comfort RS seat heating

Retrofit Comfort RS seat heating system

The high-quality carbon seat heating system was developed for retrofitting in individual seats.

You can switch off the heat supply of the carbon surface heating elements via a round switch (0% power) or set it to one of 2 different heating modes:
High: 100% power = full power for quick warm-up.
Low: 25% power = pleasant warmth in continuous operation

Differences of the carbon surface heating elements to heating elements of the stranded wire technology:
The carbon surface heating elements have considerable advantages over the previously widespread heating elements in stranded wire technology. For example, only carbon heating elements can be adapted and trimmed during installation. With conventional stranded wire technology, a heating wire runs in waves inside the heating element. If this is damaged at any point, e.g. by mechanical stress or overheating, the entire heating element fails. The new carbon surface heating elements use parallel technology. Many carbon heating fibres run independently of each other within the heating element, guaranteeing its reliability. The heat distribution of the carbon heating elements is much more homogeneous and therefore more comfortable.

Scope of delivery:
2 carbon heating mats (one for the seat and one for the back).
1 cable harness
1 switch
incl. necessary installation material and installation instructions

Technical data:
Size of heating mats: 645 x 250 mm (can be trimmed according to installation instructions).
Operating voltage: 9.6 V - 15 V
Operating temperature range: -20 °C to +80 °C
Power: up to 90W@13.8V
Certification: ECE, EMV

In our shop you can alternatively buy a 3-stage adjustable seat heater that reaches the desired heating power in just a few minutes.